MITSUBISHI Gear Motor – GM-SSY series

Exxellent drive characteristeristcs of the inverter
- Achieves a wide constant torque range in standard modle with the use of Mitsubishi inverters
Low nouse
- A noise Level lower than conventional models has been achieved by the smooth power transmission made possible by the optimum Super Helicross gear design (Lower by 3 to 4 dB (A) compared to conventionnal Mitsubishi Models).
Microminiaturization
- The distance from the output shaft to the case end face (dimension C) has been minimized to the smallest size possible, enabling the motors to be installed easily on small-sized machines.(Dimemsion C is the same for the three faces.)
Shared methods for munting
- The motors are designd to designed to allow both flange and face-munting methods. Changing the methld for connecting with machines will not require a change of the motor model.
- In the case of flange mounting use the M 8 hexagon socket head cap screws. (Make sure to use the supplied special washers.) * the bolt hole diameter conforms to JIS class 1. please chack the mounting dimensions beforehand.
- IN the case of face mounting Use M 10 bolts

MITSUBISHI Gear Motor - GM-SSY series

MITSUBISHI Gear Motor – GM-SSY series

Exxellent drive characteristeristcs of the inverter
- Achieves a wide constant torque range in standard modle with the use of Mitsubishi inverters
Low nouse
- A noise Level lower than conventional models has been achieved by the smooth power transmission made possible by the optimum Super Helicross gear design (Lower by 3 to 4 dB (A) compared to conventionnal Mitsubishi Models).
Microminiaturization
- The distance from the output shaft to the case end face (dimension C) has been minimized to the smallest size possible, enabling the motors to be installed easily on small-sized machines.(Dimemsion C is the same for the three faces.)
Shared methods for munting
- The motors are designd to designed to allow both flange and face-munting methods. Changing the methld for connecting with machines will not require a change of the motor model.
- In the case of flange mounting use the M 8 hexagon socket head cap screws. (Make sure to use the supplied special washers.) * the bolt hole diameter conforms to JIS class 1. please chack the mounting dimensions beforehand.
- IN the case of face mounting Use M 10 bolts

Gear Motor Model	GM-SSY series
Output	0.1 to 0.4 kW
Number of poles	4 P
Number of phases	3-phase
Voltage	200/200/220 V
Frequency	50/60/60 Hz
Gear ratio	1/7.5 to 1/60 (See the model configration list.)
Rating	Continuos
Heat resistance class	120 (E)
Starting method	Dieect start
Casing construction	Totally-enclosed fan-cooled type (totally-enclosed type only for 0.1 kW models)
Protective construction	Indoor type (equivalent to IP44)
Output Shaft	Hollow shaft
Mounting method	For both flange and face mounting mehods
Mounting direction	Installation in any direction
Installation location	INdoors (without corrosive gas, oil mist, flammable gas and dust)
Ambient temperature	-15 to 40 ^๐C (non condensing)
Ambient humity	90 % RH less
Altitude	1000 m or less above sea level
Vibration	Normally : 4.9 m/s² or less Instantaneously 9.8 m/s ² or less
Brake type	DC spring brake
Applicable Standards	JEC, JEM
Lubrication method	Grease lubrication (filled with TOUGHLIX GREASE GM)
Paint color	silver (equivalent to Munsell N 6.0)
Accessories	Output shaft protective cover and special washers