OMRON Safety Door Switches – D4NS / D4NS-SK

Specifications | Safety Door Switches – D4NS / D4NS-SK series

Standards and EC Directives

Conforms to the following EC Directives:

• Machinery Directive
• Low Voltage Directive
• EN50047
• EN60947-5-1
• EN ISO 14119
• GS-ET-15

Certified Standards

Certification body	Standard	File No.
TÜV SÜD	EN60947-5-1 (certified direct opening)	Consult your OMRON representative for details.
UL *1	UL508, CSA C22.2 No.14	E76675
CQC (CCC)	GB/T 14048.5	Consult your OMRON representative for details.
KOSHA *2	EN60947-5-1	Consult your OMRON representative for details.

*1. Certification for CSA C22.2 No. 14 is authorized by the UL mark.
*2. Only certain models have been certified.

Certified Standard Ratings

TÜV (EN60947-5-1), CCC (GB/T 14048.5)

Utilization category	AC-15	DC-13
Rated operating current (Ie)	3 A	0.27 A
Rated operating voltage (Ue)	240 V	250 V

Note: Use a 10 A fuse type gI or gG that conforms to IEC60269 as a short-circuit protection device. This fuse is not built
into the Switch.

UL/CSA (UL508, CSA C22.2 No. 14)

A300

Rated voltage	Carry current	Current (A)		Volt-amperes (VA)
		Make	Break	Make	Break
120 VAC	10 A	60	6	7,200	720
240 VAC		30	3

Q300

Rated voltage	Carry current	Current (A)		Volt-amperes (VA)
		Make	Break	Make	Break
125 VDC	2.5 A	0.55	0.55	69	69
250 VDC		0.27	0.27

Characteristics

Interlock type		Type 2 (EN ISO 14119)
Coding level		Low level coded (EN ISO 14119)
Degree of protection *1		IP67 (EN60947-5-1)
Durability *2	Mechanical	Standard type: 1,000,000 operations min. High pull-force type: 100,000 operations min.
	Electrical	Standard type: 500,000 operations min. (3 A resistive load at 250 VAC) *3 300,000 operations min. (10 A resistive load at 250 VAC) High pull-force type: 100,000 operations min. (10 A resistive load at 250 VAC)
Operating speed		0.05 to 0.5 m/s
Direct opening force *4		Standard type: 60 N min. High pull-force type: 80 N min.
Direct opening travel *4		10 mm min.
Contact resistance		25 mΩ max.
Minimum applicable load *5		1 mA resistive load at 5 VDC (N-level reference value)
Rated insulation voltage (Ui)		300 V
Rated frequency		50/60 Hz
Protection against electric shock		Class II (double insulation)
Pollution degree (operating environment)		3 (EN60947-5-1)
Impulse withstand voltage (Uimp) (EN60947-5-1)	Between terminals of same polarity	2.5 kV
	Between terminals of different polarity	4 kV
	Between each terminal and non-current carrying metallic parts	6 kV
Insulation resistance		100 MΩ min.
Contact gap		2 × 2 mm min.
Vibration resistance	Malfunction	10 to 55 Hz, 0.75 mm single amplitude
Shock resistance	Destruction	1,000 m/s2 min.
	Malfunction	300 m/s2 min.
Conditional short-circuit current		100 A (EN60947-5-1)
Conventional free air thermal current (Ith)		10 A (EN60947-5-1)
Ambient operating temperature		-30 to 70°C (with no icing)
Ambient operating humidity		95% max.
Weight		Approx. 96 g (D4NS-1CF)

Note: 1. The above values are initial values.
2. The Switch contacts can be used with either standard loads or microloads. Once the contacts have been used to
switch a load, however, they cannot be used to switch smaller loads. The contact surfaces will become rough
once they have been used and contact reliability for smaller loads may be reduced.
*1. The degree of protection is tested using the method specified by the standard (EN60947-5-1). Confirm that sealing
properties are sufficient for the operating conditions and environment beforehand. Although the switch box is
protected from dust or water penetration, do not use the D4NS in places where foreign material may enter through the
key hole on the head, otherwise Switch damage or malfunctioning may occur.
*2. The durability is for an ambient temperature of 5 to 35°C and an ambient humidity of 40% to 70%. For more details,
consult your OMRON representative.
*3. Do not pass the 3 A, 250 VAC load through more than 2 circuits.
*4. These figures are minimum requirements for safe operation.
*5. This value will vary with the switching frequency, environment, and reliability level. Confirm that correct operation is
possible with the actual load beforehand.

Dimensions | Safety Door Switches – D4NS / D4NS-SK series

(Unit: mm)

1-Conduit Types

D4NS-1[]F
D4NS-2[]F
D4NS-4[]F
D4NS-2[]F-SJ
D4NS-4[]F-SJ

2-Conduit Types

D4NS-6[]F
D4NS-8[]F

1-Conduit Connector Types

D4NS-9[]F

Note: 1. Unless otherwise specified, a tolerance of ±0.4 mm applies to all dimensions.
2. There are fluctuations in the contact ON/OFF timing for Switches with multiple poles (2NC, 2NC/1NO, or 3NC).
Confirm performance before application.

Operation Keys

D4DS-K1

D4DS-K2

D4DS-K3

D4DS-K5

Note: Unless otherwise specified, a tolerance of ±0.4 mm applies to all dimensions.

Slide Keys

D4NS-SK01

Main Body

Auxiliary Mounting Bracket and Receptacle Bracket

Switch Mounting Pattern 1

Switch Mounting Pattern 2

D4NS-SK30

Open Door

Closed Door

With Operation Key Inserted (Relationship between Insertion Radius and Key Hole)

D4NS-1[]F + D4DS-K1
(with Front-inserted Operation Key)

D4NS-1[]F + D4DS-K1
(with Top-inserted Operation Key)

D4NS-1[]F + D4DS-K2
(with Front-inserted Operation Key)

D4NS-1[]F + D4DS-K2
(with Top-inserted Operation Key)

D4NS-1[]F + D4DS-K3
(with Front-inserted Operation Key)

D4NS-1[]F + D4DS-K3
(with Top-inserted Operation Key)

D4NS-1[]F + D4DS-K5
(with Front-inserted Operation Key)

D4NS-1[]F + D4DS-K5
(with Top-inserted Operation Key)

Note: Unless otherwise specified, a tolerance of ±0.4 mm applies to all dimensions.
* Insertion radii apply when the rotational center of the Operation Key is in line with a line extending from the front or top Head surface.

Features | Safety Door Switches – D4NS / D4NS-SK series

• Multi-contact, environment-friendly, next-generation safety-door switch
• Lineup three contact models with 2NC/1NO and 3NC contact forms and MBB models 1NC/1NO, and 2NC

---

Properties | Safety Door Switches – D4NS / D4NS-SK series

Safety Door Switches	D4NS	D4NS-SK
Type	แบบ Standard / High pull-force
Direct opening force	60 / 80 นิวตัน
Max Actuation Frequency	30 operations / min
Max Actuation Speed:500 mm / s	500 mm /s
Weight	96 g
Built-in Switch	1 NO/1 NC , 2 NC , 2 NC/1 NO , 3 NC ( Slow-action )
	1 NC/1 NO , 2 NC/1 NO ( MBB contact )
IP	67
Option	–	Replacement Contact Block
	–	Micro Style Cables
	–	Cabling Components
	–	Conduit LED Beacons
	–	Security Bits / Devices